Finishing Operator

• Prepare before winding.       打线前准备

• Check the massage of order and the drugline.         核对订单和料单的信息
• Paste a little thread into the order, and signature in the order paper after check.     核对信息无误后，贴一缕线样到订单上，并在旁边签名。

• Operate the winding  machine .        操作打线机

• Choose the correct method to winding the thread.      选取对应的程序打线
• Pay attention to the winding machine  if there is alarm.      关注打线机的运行状态，及有无报警。
• Winding the thread by duedate。       按照交期打线
• Put the remainder PKG to the shelf of the WIP, and put the cones to the blue box.     将剩余的PKG放到WIP区，将成品cone放到蓝色的框子里。

• 5+1S of his/her working place        工作场所的5+1S

• Keep clear of the winding machine and floor around it .      保持打线机及周围地面的清洁。
• Keep clear and  trimly of all the place he/she worked   保持工作场所的干净整洁。

• Preparation before packing.    包装前准备。

• Check order and drugline information.  核对订单和料单的信息
• Count out the no. of cones and make sure if it can match the order.   

清点线cone的数量是否和订单数量一致

• Check out the cones to see if it match the order.  检查线cone是否与订单一致
• Check out the small and big label, making sure it can match the order.  

检查大小标签，确保信息与订单一致。

• Packing of finished cones.  成品cone的包装

• Snip off the ends of the cones before packing. 包装前首先要剪掉尾线。
• Make a knot at the end of the cones if needed.   如有需要在尾线处打结。
• Sticking the small label onto the cones and then pack into plastic bag. 

在成品cone上贴上小标签,然后包入包装袋。

• Put the finished cones into proper packing boxes, and stick big labels on the boxes.

将成品cone放到包装盒中，并在包装盒上贴上大标签。

• YDES in SAP.   SAP 的入仓

• Check order quantity to see if it the same with finished cones.   

   核对订单的需求数量和包装好的成品cone的数量。

• Do YDES according to the cones packed. 按照实际包装的数量入仓。

•  工作场所的5+1S

• Keep cleaning of the winding machine and floor around it.  保持打线机及周围地面的清洁。
• Keep cleaning of all the place he/she worked   保持工作场所的干净整洁。